Epoxy repair putty is a mixture of clear, high strength, fiber reinforced epoxy resin and an amazing solar activated catalyst. There is no mixing required. Just use it right from the tube. It gels in 5 seconds, curing in 3 minutes – but ONLY when exposed to sunlight.
No mixing necessary. UV curing assures complete hardening.
Contains urethanes that prevent yellowing
ECO-FriendlyZERO vapors, non-flammable.
We promise to never spam you, and just use your email address to identify you as a valid customer.
The product works great, but sets up too fast. Within 5 seconds is got clumpy. You better be prepared to work super fast!!!!
Posted byGary Arreagaon 15th Jul 2017
I found a chip/dent on the rail of my stand up paddle board. It was about the size of a dime. Once I removed the compromised surface I realized the foam core was also compromised. When I was done cleaning the area out. The damage was dime sized and about 3/8 inch deep. Using Solarez I slightly filled the compromised area, applied a clear flexible plastic over the area as to compress and spread the epoxy beyond the damaged area. Exposed it to sunlight for about 10min. Thats it, done. Great porduct!!
After my board and other items took flight off my roof when my roof rack broke while going 80+ mph down the highway I was left with five large areas that cracked through the fiberglass. I was seriously contemplating taking a circular saw to it and cutting it down the middle to make shelving out of it until I heard of this product.
I cut out the cracked fiberglass with a dremel and sanded the edges of the cuts. I then went to fill in my first area basically using half the tube, put it in the sun, and the styrofoam shrank during the curing process leaving a large void/bubble under the semi cured layer of resin. I didnt like that, so I cut it out and tried again. I found brushing on a very thin layer onto the foam and curing that as my base worked very well. I was working with very complexed curves (the back corners, sides, and nose) so I used clear packing tape to build dams for the resin and just worked in layers until the void was filled it. Once cured it sanded very easy and wet sanded to a glossy finish.
– brush on a thin layer first as a base
– use clear packing tape to contour rough shape
– brush on final layer after filled in to seal edges
– UV rays for a setting sun arent as effective, morning sun works better
This is a great product to fix dings in your SUP
Incredibly easy to use, and very helpful/informative staff.
After being told by several local SUP shops that I should take my board to a professional for my problem, I was informed of this product by my father who had used it on his SUP. I managed to patch an exposed stringer on the nose of my Carbon Fiber SUP without issue!
Highly recommend the Solarez product line!
Used it on my carbon fiber sup and it did a great job. I used a dremel to help shape the damaged area.
Flex Finish Doming ResinA clear, non yellowing, flexible resin for putting a
SUP Pro Repair Kit contains: ZEROVOC styrofoam-safe UV-Cure fiberfil
Thick, Hard GLOW IN THE DARK Formula – Glows in the dark for enhanced night